PT 100 Adobe finish for exterior base or mesh coated surfaces, min 1mm.
PT 101 A plastic trowel finish over all base or mesh coated surfaces or directly over 7.5mm fibre-cement sheet, min 1mm. Also suitable as a texture spray.
PT 102 A medium sponge finish for exterior base or mesh coated surfaces, min 1.5mm. Also suitable as a texture spray.
PT 103 A 2 or 3mm scratch finish.
PT 104 A 2 or 3mm drag finish.
PT 200 A robust render suitable as a basecoat on concrete block or AAC, 5—20mm.
PT 300 A general purpose adhesive render used as a basecoat over polystyrene (EPS) and smooth surfaces such as precast and tiltslab or painted
surfaces, min 3-4mm on polystyrene. Can be used to x polystyrene sheets to all common good bearing wall backgrounds.
PT 320 A 2—4mm mesh coat render for use as a mesh or straightening coat over PT 300 or PT 325.
PT 325 A basecoat render that adheres directly to bre-cement sheet, min 5mm.
PT 350 A bonding and straightening plaster used in thin coat plaster solutions for min 7.5mm fibre-cement sheet. Retarded hydration allows this
to be used as a skim coat over high suction substrates, min 1mm.
PT 350 AAC Block Render Mineral Plaster on autoclaved aerated concrete block wall.
PT 351 A jointing compound used with rebated 7.5mm fibre-cement sheets.
PT 402 A gypsum/lime whiteset render for high level polished internal finishing
PT 451 An adhesive whiteset basecoat over polystyrene , precast or painted surfaces.
PT 600 An insulating plaster for blockwork and fibre-cement sheet.
HYROQUEL A masonry waterproofing agent.